PolyPhaser Grounding Solutions



Where coaxial cables enter a facility and both grounding of the outside shield and coaxial surge protectors are desired to protect electronic equipment as well as for establishing a central single point ground location.

bulletAccommodates up to 3-1/8" rigid line (without FIA flange) and up to EW28 type elliptical line (without flange) including coaxial cables
bulletWeather-boot protected cable grounding kit
bullet6" wide 15' long copper straps provide low inductance, large surface area conductors with sandwich bar connection and joint compound for system lug or exothermic interconnection to the perimeter ground cable
bulletBoot made of EPDM +300, -60F, excellent UV and atmospheric stability, expands to 200% to fit over cable
bulletInside horizontal plates provide sandwich connections to flexible copper straps for grounding the coaxial protectors
bulletDesign allows for various length cable connections to the surge  protectors and accommodates cable entry
bulletHorizontal plates have hole locations for bolting other equipment grounding cables to form a single point facility ground


Material: C 110 half hard copper
Hardware: Stainless steel and brass
Boots: UV & weather resistant EPDM rubber


All the parts listed below  in black have been replaced by:


Combinations may be made by multiples of the 5 and 8 port systems.


3PEEP 3 port system, two 6' wide straps

5PEEP 5 port system, two 6' wide straps

8PEEP 8 port system, two 6" wide straps

10PEEP 10 port system, four 6" wide straps (two-5 PEEP)

16PEEP 16 port system, four 6" wide straps (two-8PEEP)

24PEEP 24 port system, four 6" wide straps (three-8PEEP)


Return to Comm-Omni Home Page


To speak to one of our consultants, please call us 
at 1-800-543-8790