EDCO Telecom/Datacom Surge Protectors

P-264

P-264 Series

The P264 Surge Protector Series is designed to protect two pairs of wires specifically for alarm and security systems where operating currents can be as high as 2.5 amps.

Electrically, the P264 Series is a rugged series hybrid surge protector implementing a staged complement of MOV's and copper wound inductors. This design reduces series resistance to 0.2 Ohms per pair. These products are intended to mate with a 12 pin industrial socket such as Custom Connector Corporation's model SD12-PC. 

The P264 Modules plug into a base assembly (SD12-PC). The base assembly can be mounted to any flat surface, and should be located as close as practical to the protected equipment. Terminal 2 and / or Terminal 5 should be connections to Building Approved ground with 12 gauge solid wire.  

FEATURES

bulletLightning Protection for Low Voltage Lines
bulletThree-Stage Protection
bulletDifferential Protection
bulletCommon Mode Protection
bulletPlug-In Module
bulletAutomatic Recovery
bulletFast Response Time
bulletContinuous Current up to 2.5 Amp
bulletUL 497B Listed

send email to Comm-Omnicomm-omni@comm-omni.comComm-Omni logo

If you have reached this page through a browser and do not have the "Comm-Omni Navigation Bar" at the top, please follow this link.

Return to Comm-Omni Home Page

Index

To speak to one of our consultants, please call us at 1-800-543-8790